Diagnosing the fuel pump is reasonably simple as soon as you execute not hear it turn on, however its replacement requires a little more work. This short article explains exactly how to safely drain your gas tank, reduced it, and relocation that dreaded fuel pump.

You are watching: 1990 honda accord fuel pump location


This post uses to the Honda Accord (1990-2002).

Your automobile demands three things to begin – fuel, spark, and air – and when one or even more of these fails to make an appearance, the engine will certainly not begin. A fuel pump is supposed to wear out over time; this is particularly common on vehicles via higher mileage. The usual case in replacing a fuel pump on a Honda chassis requires opening the access hatch discovered behind the seat and also simply replacing the pump. Unfortunately, fourth and fifth-generation Honda Accord owners appeared to have actually obtained the raw finish of the deal once it concerns fuel pump availability. Fourth and fifth-generation Honda Accord owners carry the burden of having actually to drainpipe the gas, drop the tank, and disaffix all the fuel lines to access the pump. Here"s just how you have the right to rearea the fuel pump and conserve a couple of hundred dollars in labor.

*


Materials NeededSocket set3/8" ratchetFuel containerPliersRagsJackJack stands

Step 1 – Siphon out the gas tank

Take a tube and insert it right into the tank, with the gas cap. Create a vacuum by blowing into the tank with the tube and pour the gasoline into a safe container. Drain out as much gas as possible.

Figure 1. Siphon gas out of the tank.
Pro Tip

Use a vacuum pump, if one is obtainable, to prevent accidentally sipping up gasoline.


Featured Video: How to Siphon Gas Without a Pump


Tip 2 – Raise and also secure the car

Use a jack on among the car"s security points and raise it. Position jack stands under the automobile to secure it right into the air.

(Related Article: How to Jack Up Your Accord - piersonforcongress.com)

*
Figure 2. Raise and also support the auto.

Step 3 – Disconnect the fuel-sfinishing unit

The fuel-sfinishing unit is uncovered underneath the accessibility hatch situated inside the trunk. Open the hatch and also disattach it.

Figure 3. Disattach the fuel-sending unit.

Step 4 – Begin disconnecting the fuel lines

Tbelow are four fuel lines that need to be disconnected, every one of which are situated behind the left rear wheel. First, remove the rear left wheel. Once off, begin disconnecting the fuel lines. Tbelow are 2 hard-lines, a high-press line, one brass line that connects straight to the tank, and a huge line for fuel input.

Figure 4. The first 2 fuel lines that need to be dislinked.Figure 5. The high-push fuel line.Figure 6. The brass fuel hard-line.Figure 7. The gas-receiving line.

Step 5 – Remove the tank straps

The tank straps are hosted in place using 14mm bolts. Place a hydraulic jack through a long item of hardwood under the tank. Loosen the straps and remove them. Once the straps are off, slowly lower to relieve the push from the jack and reduced the tank.

Figure 8. The gas tank straps.
Pro Tip

The exhaust heat shield might need to be rerelocated to accessibility among the 14mm strap bolts.


Step 6 – Rerelocate the fuel pump

First, disconnect the clip on height of the fuel pump. Then, use a 10mm socket to remove the nuts that secure the fuel pump to the tank. Once all the nuts are off, pull the unit out from the tank and also remove the pump from its bracket.

Figure 9. Disattach the clip on the fuel pump.Figure 10. Remove the pump.

Step 7 – Install the brand-new pump

Mount the new pump to its holder and also be certain to effectively place it inside the gas tank. There is a small plastic container located inside the tank. Position the pump so that it sits inside the plastic container, wright here the fuel pick-up is.

Figure 11. Mount the brand-new fuel pump.

See more: Where Is The Colossus Boulevard Smith S? Smith In Colossus Boulevard

Step 8 – Mount the fuel tank and also lines

Once done, raise the tank and also secure the straps. Reconnect all the fuel lines and be sure to tighten the high-press line. Put the wheel back on and reduced the car. Open the gas cap, pour some fuel and begin her up!

Figure 12. Raise the tank and reattach all the fuel lines.

Featured Video: Honda Accord Fuel Pump and also Fuel Tank Removal


Related Discussion