I"ve viewed this problem elsewhere, yet I haven"t found a solution. I need to remove the lens from my fluorescent light fixture so ns can readjust the bulbs. It shows up the only way to eliminate the lens would certainly be come remove one of the finish caps top top the fixture therefore the lens could slide out. However I can"t view any means to remove the end caps. To eliminate them, it appears the pressure that would certainly be required may be good enough to rest them. I"ve never seen together a poor design for a basic device. I could article photos if that would help.

You are watching: How to remove cover from fluorescent light fixture


*


Pic"s always help. Many times friend just need to flex the clear cover over one side, climate it comes appropriate off.

The lens extends well into the finish caps. Over there is no method sliding the lens either method and then flexing it would permit it to it is in removed.
Sometimes you get lucky and the entirety frame w/lens lifts and can it is in jiggles loose. Otherwise, the is a video game if angles and also patience. Shot to gain one side together high as feasible while pulling under on the other. Carry out this ~ the light has been on for a while therefore the plastic lens is a small warmer and not together brittle. I"ve had success, I"ve also had to replace a pair that were less than cooperative.
My guess is the one or both end caps breaks on and can be eliminated by tapping it near the ceiling to popular music it turn off the fixture. The lens would then slide out, offering you access to the tubes.
I"ll shot tapping one end cap off. So far I"ve just been trying to pry that off. Together I mentioned, sliding the lens completely into either end cap does not permit the opposite finish of the lens come come all over near dropping down.Added: goldstar wins! The plastic end caps are organized to the fixture through two protruding tabs on each side that the finish cap. Unfortunately, tapping easy on one end damaged these plastic tabs off. I don"t care!I now see the correct means is come press really firmly in ~ above the end of the metal fixture come deform the area so this tabs would then clean the steel fixture"s holes. V the finish cap off, the lens slides out.

See more: What Get Wetter The More It Dries ? Find The Answer Now At Quick Answer


Too negative you had to break the tabs turn off one finish cap to discover the trick, but, happy you got it resolved and also thank you for the feedback.
I installed a pair of new 6000K daylight tubes and also the area looks an excellent now. So much so, I want to change the various other two still functioning tubes in a nearby fixture. Fortunately, its lens has a ridge on each side that simply lifts up turn off the fixture. I"m an professional now!
I love those. Ns forget what remained in our to wash room when we bought this house, but I instantly replaced every little thing it was v two two-tube T-8 fixtures, one 4" and one 2", join end-to-end, and installed 6500K lamps (I think they are) in them. That"s 120W of daylight ideal down the facility of the room. If friend don"t watch a point out on the clean clothes in the room, you sure won"t see one somewhere else!Hey! walk for it, expert!
*
*

piersonforcongress.com®, founded in 1995, is the top independent home innovation and repair website. We welcome your comments and also suggestions. All information is provided "AS IS." Website operation problems call webmaster