I spent quite a little bit of time searching the net trying to get instructions just how to check and adjust transmission liquid in a 2001 Isuzu Rodeo, however all I might find was the same info copied and pasted from site to site, and no photos. For this reason I functioned my situation out and also took a pair of image to help others be sure of what they’re acquisition on once they do the same work.These photos are taken from under the passenger side of the truck, through the van sitting ~ above the ground. Ns did not have to raise it to gain the job done. The vehicle has manufacturing facility suspension.As friend probably recognize by now, over there is no dipstick under the hood, nor is there a means to add fluid easily. In ~ the behind of the pan, underneath, over there is a bolt you remove to drain the fluid. Approximately six inch from the bolt, there is another bolt. That is around 3 - 4.5 inches greater than the drainpipe plug, as the architecture of the pan is such that one edge (that corner) is created to sit higher in the pan (photo).The means to examine the fluid is to eliminate the plug (upper bolt) and also if fluid drains out--you’re good. This is disastrous planning, because if it’s low, you can’t tell just how low. Yet it is just how it works. So, friend pump some fluid in till it leaks the end that exact same hole. Once the fluid starts to operation out that that very same hole, you’re good. To replace the fluid, you drain it an initial (out that the other, reduced plug) then change the drain plug and also fill it till it leaks indigenous the upper.Another difficulty with this process is, you need to pump the liquid upwardly--from beneath the vehicle against gravity--to acquire the liquid in. To accomplish this, you require a pump. I gained an enough pump at my nearest auto parts store for $2.99. Off one end of the straightforward hand pump runs about four feet of clear hose, comparable to what you can use for a residence aquarium. Affixed to the other finish of the hand pump is a nipple/plastic fixture that fits right into the fill hole top top the pan. You have to put the end of the lengthy hose right into the quart party of fluid and physically pump it into the pan. It help if you usage the extra clip of the hose to elevate the fluid bottle. That means gravity helps, considerably, feeding the liquid from the party to the pump. I placed in one party of fluid, confirm the level, and also then started the next bottle. From over there on I confirm the level each half-bottle ns added. It took me exactly three quarts. I have actually a six-cylinder motor and I think the takes around nine quarts to totally refill the whole thing, prefer a professional shop would certainly do. Yet the simple process (drain and also fill) I define here required exactly three quarts.I hope this help you. You can do it. If you have actually questions ns will shot to answer. I am no an auto mechanic--just a man who has a 2001 Isuzu Rodeo.Good luck.wannabe.mechanic


You are watching: 2001 isuzu rodeo transmission fluid check

*

*

*

*



See more: Voulez-Vous Coucher Avec Moi Ce Soir Pronunciation, How To Pronounce Voulez

Type your question in this box.
What is your very first name?
I must have your email deal with to answer.
Hit the button below to send her question.